Chrysler PT Cruiser 2001 Service Manual Supplement page 1124

PT
REMOVAL AND INSTALLATION (Continued)
Fig. 15 Throttle Body—2.4L Engines
1 – IAC
2 – PCM
3 – TPS
(3) Remove the engine cover or throttle control
shield if equipped.
(4) Remove throttle cable from the throttle body
lever (Fig. 16) and (Fig. 17).
Fig. 16 Throttle Cable Attachment to Throttle Body
(5) Lift the retaining tabs on the cable and slide
cable out of bracket.
(6) If equipped with speed control, remove speed
control cable from throttle lever by sliding clasp out
hole used for throttle cable.
(7) Remove EVAP purge hose from nipple on throt-
tle body.
(8) Remove the electrical connectors from the
throttle position sensor and idle air control motor.
Fig. 17 Disconnecting Throttle Cable
(9) Remove 2 screws holding cable mounting
bracket and support bracket.
(10) Remove throttle body mounting bolts (Fig.
18).
Fig. 18 Throttle Body Bolts
(11) Lift throttle body straight up and to remove
the throttle body (Fig. 19).
INSTALLATION
(1) Attach electrical connectors to idle air control
motor and throttle position sensor.
(2) Make sure that the throttle body gasket is
inplace in the manifold.
(3) Position throttle body on intake and install
mounting bolts (Fig. 19). Do Not tighten bolts at this
time.
FUEL SYSTEM 14 - 37