Chrysler PT Cruiser 2001 Service Manual Supplement page 1848

*COURTESY LAMPS ON AT ALL TIMES —
TEST
2 Open the Drivers door.
Disconnect the Driver Door Ajar Switch connector.
With the DRB III select: Body Electro/Mech Cluster Input/Output
Read the Dvr Door Ajar Sw state.
Does the DRBIII show: Open ?
Yes → Replace the defective Door Ajar Switch.
→ Go To 3
No
3 Turn ignition off.
Disconnect the driver door ajar switch connector.
Disconnect the Instrument Cluster connector.
Disconnect the RKE Module connector.
Measure the resistance of the Driver Door Ajar Switch Sense circuit from the door
ajar switch connector to ground.
Is the resistance below 100.0 ohms?
Yes → Repair the Driver Door Ajar Switch Sense wire for a short to
→ Go To 4
No
4 Ensure the Instrument Cluster is connected at this time.
Disconnect the RKE Module connector.
With the DRB III select: Body Electro/Mech Cluster Input/Output
Read the Dvr Door Ajar Sw state.
Does the DRBIII show Drv Door Ajar Sw: Open ?
Yes → Replace the Remote Keyless Entry Module (driver door ajar
→ Go To 5
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
ground.
Perform BODY VERIFICATION TEST - VER 1.
shorted).
Perform BODY VERIFICATION TEST - VER 1.
Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1.
INTERIOR LIGHTING
Continued
199
APPLICABILITY
All
All
All
All