Blower Unit - Mazda RX-8 Manual

Hide thumbs Also See for RX-8:

Table of Contents

BLOWER UNIT

BLOWER UNIT REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:

b. Console (See CONSOLE REMOVAL/INSTALLATION .)

c. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)

d. Side panel (See SIDE PANEL REMOVAL/INSTALLATION .)

e. Lower panel (See LOWER PANEL REMOVAL/INSTALLATION .)

f. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)

g. Steering shaft installation nuts (See STEERING WHEEL AND COLUMN

REMOVAL/INSTALLATION .)

h. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION .)

i. Dashboard (See DASHBOARD REMOVAL/INSTALLATION .)

3. Remove the A/C unit from the dashboard.

4. Remove the blower unit as shown in the figure.

5. Install in the reverse order of removal.

BLOWER UNIT DISASSEMBLY/ASSEMBLY

1. Disassemble in the order indicated in the table.

If a non-specified grease is used, it may result in abnormal noise or improper operation of the

links. Apply only the specified grease to each link.