Mazda RX-8 Manual page 1462

DSC SYSTEM INSPECTION
Preparation
1. Verify that battery is fully charged.
2. Turn the ignition switch to the ON position, and verify that the ABS warning light goes out after
approx. 3 s .
3. Turn the ignition switch off.
4. Jack up the vehicle and support it evenly on safety stands.
5. Shift to the N position.
6. Verify that all four wheels rotate.
7. Rotate the inspected wheels by hand, and verify there is no brake drag.
If there is any brake drag, perform regular brake inspection.
•
If there is no brake drag, perform DSC HU/CM operation inspection.
•
ABS Control Inspection
1. Perform "Preparation".
2. Connect the WDS or equivalent to the DLC-2.
3. Set up an active command mode inspection according to the combination of commands below.Brake
pressure retention
Command name
LF_TC_VLV
RF_TC_VLV
LF_DSC_V
RF_DSC_V
ABS_POWER
LF_INLET
LF_OUTLET
LR_INLET
LR_OUTLET
RF_INLET
RF_OUTLET
RR_INLET
Inspected wheels
LF RF LR RR
OFF
ON
ON
OFF
OFF
OFF
ON
OFF
OFF
ON
OFF
ON
(w) RX8 - Brakes
Page 48