Mazda RX-8 Manual page 1344

18. Inspect for continuity between TR switch terminals C and D.
19. Remove the SST .
20. Install the manual shaft lever component and washer.
CAUTION:
Do not use an impact wrench. Hold the manual shaft lever when tightening the manual shaft nut,
•
otherwise the transmission may be damaged.
21. Set the adjustable wrench as shown in the figure to hold the manual shaft lever.
22. Tighten the manual shaft nut using a torque wrench.
Tightening torque
2333 N·m {2.33.4 kgf·m, 1724 ft·lbf}
o
23. Shift the selector lever to the P position.
24. Turn the manual shaft lever to the P position.
25. Inspect TR switch continuity. (See Continuity Inspection .)
26. Connect the TR switch connector.
27. Align the mark of the manual shaft lever component as shown in the figure.
(w) RX-8 Transmission (Manual & Auto)
Page 319