Mazda RX-8 Manual page 1526

DTC B2477 [DYNAMIC STABILITY CONTROL]
DTC B2477
DETECTION CONDITION
POSSIBLE CAUSE
Diagnostic procedure
STEP INSPECTION
VERIFY CONFIGURATION
1
Has the DSC HU/CM configuration been
•
performed?
VERIFY DTC TROUBLESHOOTING
COMPLETED
2
Clear the DTC from the memory.
•
Is the same DTC present?
•
VERIFY AFTER REPAIR PROCEDURE
3
Are any other DTCs present?
•
DSC HU/CM configuration
Configuration setting failure is detected.
•
Module configuration procedure was not completed properly.
•
ACTION
Yes Go to the next step.
Perform configuration using the WDS or
No
equivalent.
Repeat the inspection from Step 1.
Yes
If the malfunction recurs, replace the DSC
HU/CM.
No Go to the next step.
Yes Go to the applicable DTC inspection.
No DTC troubleshooting completed.
(w) RX8 - Brakes
Page 112