Mazda RX-8 Manual page 1345

28. Install the manual shaft lever component installation nut.
Tightening torque
10.814.7 N·m
o
{1.11.4 kgf·m, 8.010.8 ft·lbf}
29. Install the insulator.
Tightening torque
811 N·m {82112 kgf·cm, 7297 in·lbf}
o
30. Install the catalytic converter.
(See EXHAUST SYSTEM REMOVAL/INSTALLATION .)
31. Connect the negative battery cable.
32. Install the battery cover.
33. Install the engine cover.
(See ENGINE COVER REMOVAL/INSTALLATION .)
34. Inspect TR switch operation. (See Operating inspection .)
TRANSMISSION RANGE (TR) SWITCH ADJUSTMENT
CAUTION:
Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that
•
water or foreign material do not enter the connector when disconnecting it.
1. Remove the engine cover.
(See ENGINE COVER REMOVAL/INSTALLATION .)
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the catalytic converter.
(See EXHAUST SYSTEM REMOVAL/INSTALLATION .)
(w) RX-8 Transmission (Manual & Auto)
Page 320