Selector Lever Removal/Installation - Mazda RX-8 Manual

If there is any malfunction, adjust the TR switch. (See TRANSMISSION RANGE (TR)
•
SWITCH ADJUSTMENT .)
6. Verify that the vehicle operates in each selected range.
SELECTOR LEVER COMPONENT INSPECTION
1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the ashtray. (See CONSOLE REMOVAL/INSTALLATION .)
5. Remove the shift knob. (See SELECTOR LEVER REMOVAL/INSTALLATION .)
6. Remove the console panel and indicator assembly. (See SELECTOR LEVER
REMOVAL/INSTALLATION .)
7. Disconnect the selector lever component connector.
8. Verify continuity as indicated in the table.
If there is any malfunction, replace the selector lever. (See SELECTOR LEVER
•
REMOVAL/INSTALLATION .)

SELECTOR LEVER REMOVAL/INSTALLATION

1. Remove the engine cover.
2. Remove the battery cover.
(w) RX-8 Transmission (Manual & Auto)
Page 284