Mazda RX-8 Manual page 2058

Replacing all keys. (When
replacing the steering lock or
similar procedure)
Changing the method for
registering additional keys.
(Method for registering other
keys using two keys that can
start the engine is disabled.)
Changing the method for
registering additional keys.
(Method for registering other
keys using two keys that can
start the engine is enabled.)
Replacing the keyless control
module.
Replacing the PCM.
New keys (two or
•
more keys)
WDS or
•
equivalent
WDS or
•
equivalent
WDS or
•
equivalent
New keyless
•
control module
Keys for
•
registration (two
or more keys)
WDS or
•
equivalent
-
New PCM
•
WDS or
•
before beginning the procedure do not
have to be new keys. Any key that is
capable of starting the engine before
beginning the procedure can be used.
Since the steering lock is replaced, keys
•
used before replacement become
unusable. Have two new keys or more
ready before beginning the procedure.
Unless keys are registered after
•
replacing the steering lock, the engine
cannot be started.
After performing this procedure it is not
•
possible to register additional keys
according to procedure No.1.The system
can be returned to the original setting.
The WDS or equivalent must always be
used to change the system setting.
This is the default setting on new
•
vehicles.
Unless keys are re-registered after
•
replacement, the engine cannot be
started. Before beginning the procedure,
verify that the customer has turned in all
of the keys for the vehicle.
Unless two or more keys are registered
•
after replacement, the engine cannot be
started.
The keys (two or more keys) readied
•
before beginning the procedure do not
have to be new keys. Any key that is
capable of starting the engine before
beginning the procedure can be used.
3
4
4
5
5
(w) RX-8 Body
Page 340