DTC P0706
DTC P0706
DETECTION
CONDITION
POSSIBLE CAUSE
Transmission range (TR) switch circuit malfunction (open circuit/short to ground)
No range signal is input from the TR switch for 100 s or more .
•
Diagnostic support note:
This is a continuous monitor (CCM).
•
MIL illuminates if TCM detects the above malfunction condition in two
•
consecutive drive cycles.
PENDING CODE is available.
•
FREEZE FRAME DATA is available.
•
AT warning light illuminates.
•
DTC is stored in TCM memory.
•
TR switch malfunction
•
TR switch misadjustment
•
Short to ground in wiring harness between TR switch terminal A and TCM
•
terminal 1D
Short to ground in wiring harness between TR switch terminal E and TCM
•
terminal 2C
Short to ground in wiring harness between TR switch terminal D and TCM
•
terminal 2B
Short to ground in wiring harness between TR switch terminal G and TCM
•
terminal 2E
Open circuit in wiring harness between TR switch terminal A and TCM
•
terminal 1D
Open circuit in wiring harness between TR switch terminal E and TCM
•
terminal 2C
Open circuit in wiring harness between TR switch terminal D and TCM
•
terminal 2B
Open circuit in wiring harness between TR switch terminal G and TCM
•
terminal 2E
Open circuit in wiring harness between TR switch terminal C and ignition
•
switch (IG1)
Short to ground between TR switch terminal C and ignition switch (IG1)
•
Damaged connector between TR switch and TCM
•
TCM malfunction
•
(w)
RX-8 Transmission (Manual & Auto)
Page 133