Rear Crossmember - Mazda RX-8 Manual

STABILIZER CONTROL LINK (FRONT/REAR)
STABILIZER CONTROL LINK INSPECTION
1. Remove the stabilizer control link from the vehicle.
2. Inspect the link for bending or damage. If there is any malfunction, replace the link.
3. Rotate the ball joint 10 times , and rock the ball joint 10 times .
4. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.
Stabilizer control link ball joint rotational torque
0.230.47 N·m {2.354.79 kgf·cm, 2.044.15 in·lbf}
o
If not within the specification, replace the stabilizer control link ball joint.
•

REAR CROSSMEMBER

REAR CROSSMEMBER REMOVAL/INSTALLATION
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly
•
cause an open circuit in the wiring harness if it is pulled by mistake. Before operations, remove the ABS
wheel-speed sensor (axle side) and move the sensor away from the harnesses.
1. Remove the exhaust pipe
2. Remove the propeller shaft.
3. Remove the power plant frame.
4. Remove the rear drive shaft.
5. Remove the rear differential.
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. Inspect the rear wheel alignment.
(w) RX-8 Suspension
Page 42