Terminal B and J (oil pressure switch B)
•
Terminal A and J (oil pressure switch C)
•
Terminal L and J (oil pressure switch F)
•
If there is continuity, inspect the wiring harness between the solenoid connector and oil
pressure switches. If there are no malfunctions with the harnesses, inspect the oil pressure
switches. (See Off-Vehicle Inspection .)
If there is no continuity, inspect the oil pressure switches for verify the oil pressure
switches are no malfunctions. (See Off-Vehicle Inspection .)
8. Connect the solenoid valve connector.
9. Install the insulator.
Tightening torque
811 N·m {82112 kgf·cm, 7297 in·lbf}
o
10. Install the catalytic converter. (See EXHAUST SYSTEM REMOVAL/INSTALLATION .)
11. Connect the negative battery cable.
12. Install the battery cover.
13. Install the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .)
Off-Vehicle Inspection
1. Remove the oil pressure switch. (See OIL PRESSURE SWITCH REMOVAL/INSTALLATION .)
2. Apply 393 490 kPa {4.0 5.0 kgf/cm
inspect for continuity between the oil pressure switch connector and the oil pressure switch screw.
If there is no continuity, replace the oil pressure switch. (See OIL PRESSURE SWITCH
•
REMOVAL/INSTALLATION .)
3. Not apply of air pressure to the oil pressure switches, and verify for no continuity between the oil
pressure switch connector and the oil pressure switch screw.
2
, 57 71 psi} of air pressure to the oil pressure switch, and
(w)
RX-8 Transmission (Manual & Auto)
Page 336