Filament Repair - Mazda RX-8 Manual

FILAMENT REPAIR

1. Clean the filament using isopropyl alcohol.
2. Attach tape to both sides of the filament.
3. Using a small brush or marking pen, apply silver paint.
4. After 2    3 min , carefully remove the tape without damaging the applied area.
CAUTION:
Do not operate the rear window defroster until the paint is completely dry. It may be cause other
•
malfunctions if it is used before paint is dry.
5. Dry the repaired part using the following procedure.
When the room temperature is 25 ° ° ° ° C {77 ° ° ° ° F} , leave as it is for 24 h .
•
When a hot air blower is used, dry with the temperature of 150 ° ° ° ° C {302 ° ° ° ° F} for 30 min .
•
(w) RX-8 Body
Page 104