Mazda RX-8 Manual page 1449

Hide thumbs Also See for RX-8:

Table of Contents

Connector Removal Note

1. Pull the lock lever up, and then remove the connector.

ABS HU/CM Removal/Installation Note

1. When removing/installing the ABS HU/CM from/to the vehicle, attach a strip of protective tape on the

ABS HU/CM connector to prevent brake fluid from entering.

Connector Installation Note

1. After connecting the connector, verify that the lock lever is completely pushed in.

ABS HU/CM INSPECTION

1. Disconnect the ABS HU/CM connector.

2. Connect the negative battery cable.

3. Attach the tester lead to the ABS HU/CM harness side connector, then inspect voltage, continuity or

resistance according to the standard (reference value) on the table.

Standard (Reference Value)

RX8 - Brakes

Troubleshooting