Mazda RX-8 Manual page 2128

Hide thumbs Also See for RX-8:

Table of Contents

Shorting the wrong terminal of the check connector may cause malfunctions. Make sure

to short only the specified terminal.

f. Turn the ignition switch to the ON position and operate the fuel pump for approx. 20 min .

The fuel pump may malfunction if it is operated without any fuel in the fuel tank (fuel

pump idling). Constantly monitor the amount of fuel being discharged and immediately

stop operation of the pump when essentially no fuel is being discharged.

g. When essentially no fuel is being discharged from the hose, turn the ignition switch to the LOCK

When operating the fuel pump with a full fuel tank, fuel discharge will become erratic

after approx. 10 min but will continue for approx. 10 min more and then essentially no

fuel will be discharged. At this time the fuel gauge needle will be at the halfway position.

h. Disconnect the jumper wire.

i. Disconnect the negative battery cable.

j. Remove the driver's side rear seat.(See REAR SEAT REMOVAL/INSTALLATION .)

k. Remove the service hole cover.

l. Remove the cap using the SST .

Troubleshooting