Combined Sensor Initialization Procedure - Mazda RX-8 Manual

COMBINED SENSOR INITIALIZATION PROCEDURE

WARNING:
Unless the initialization procedure of the combined sensor is completed, the DSC will not operate,
•
causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC
operation if the combined sensor and DSC HU/CM have been removed or replaced.
1. Inspect the wheel alignment and inflation pressure.
If there is any malfunction, adjust the applicable part.
•
2. Park the vehicle on level ground.
3. Turn the ignition switch off.
4. Connect the WDS or equivalent to the DLC-2.
5. Access the active command mode, select the following commands, and then follow the indication on the
monitor.
YAWRATE (Yaw rate)
LATACCEL (Lateral acceleration)
6. Drive the vehicle forward.
7. After 5 min of driving, verify that the DSC system is normal.
If there is any malfunction, replace the combined sensor.
•
Standard
When the sensor is rotated to the right:
o
YAW_RATE changes negatively.
When the sensor is rotated to the left:
o
YAW_RATE changes positively.
(w) RX8 - Brakes
Page 62