Mazda RX-8 Manual page 2061

3. Verify that the security light illuminates for approx. 3 s and then goes out.
4. Using key 1, turn the ignition switch to the LOCK position within approx. 4 s after the security light
goes out.
5. Remove key 1
6. Repeat Steps 25 using key 2.
7. Repeat Steps 25 using key 3.
8. If additional keys need to be registered, repeat Steps 17 in the same manner as key 3.
No.2 Additional Key Registration Procedure (Using the WDS or Equivalent)
Conditions
Customer has only one valid key. Or customer has no valid keys. (Can also be performed even if there
•
are two or more valid keys)
NOTE:
A maximum of eight keys can be registered for any one vehicle. If key registration is not successful and
•
DTC 15 appears even though the procedure was performed properly, use the WDS or equivalent and
verify the number of keys that have been registered.
If eight keys have already been registered, and it is necessary to register other keys, the previously
•
registered key ID numbers must first be cleared. Perform key ID number clearing according to " No.3
Key Replacement Procedure (Clearing Previously Registered Key ID Numbers, Key Re-registration) ".
Procedure
1. Have one key (key 1) ready for registration.
2. Using key 1, turn the ignition switch to the ON position.
(w) RX-8 Body
Page 343