Mazda RX-8 Manual page 1799

3. Remove the sealant by pulling it off.
4. Remove the windshield.
Reusing Windshield
NOTE:
Before removing the windshield from the body, mark the position of the windshield by affixing tape to
•
the windshield and body panel.
1. Make a hole through the sealant from the inside of the vehicle using an awl, avoiding the pins.
2. Pass the SST (piano wire), cut to sufficient length, through the hole.
WARNING:
Using the SST (piano wire) with bare hands can cause injury. Always wear gloves when using
•
the SST (piano wire).
3. Wind each end of the SST (piano wire) around a bar.
NOTE:
(w) RX-8 Body
Page 81