Mazda RX-8 Manual page 1166

Inspect for continuity between the selector
•
lever (wiring harness-side) and body ground.
M range switch position: terminal B
and body ground
Up switch position: terminal D and
body ground
Down switch position: terminal F
and body ground
Is there continuity?
•
VERIFY TROUBLESHOOTING OF DTC P0707
COMPLETED
Make sure to reconnect all disconnected
•
connectors.
Clear the DTC from the TCM memory using
•
9
the WDS or equivalent.
Drive the vehicle in M range, and change
•
gears by shifting the selector lever
(operating the up and down switches).
Is the same DTC present?
•
VERIFY AFTER REPAIR PROCEDURE
Perform the "After Repair Procedure".
•
10
(See AFTER REPAIR PROCEDURE .)
Are any DTCs present?
•
No Go to the next step.
Replace the TCM, then go to the next step.
Yes
(See TCM REMOVAL/INSTALLATION .)
No No concern is detected. Go to the next step.
Go to the applicable DTC inspection.
Yes
(See DTC TABLE .)
No DTC troubleshooting completed.
(w) RX-8 Transmission (Manual & Auto)
Page 141