Dsc Hu/Cm Inspection - Mazda RX-8 Manual

Hide thumbs Also See for RX-8:

Table of Contents

2 Brake fluid pressure sensor connector

3 Brake pipe

Connector Removal Note

1. Rotate the lock lever in the direction of the arrow, and remove the DSC HU/CM connector.

DSC HU/CM Removal/Installation Note

1. When removing/installing the DSC HU/CM from/to the vehicle, attach a strip of protective tape on the

DSC HU/CM connector to prevent brake fluid from entering.

Connector Installation Note

1. After connecting the connector, rotate the lock lever in the direction of the arrow to install the DSC

HU/CM connector.

DSC HU/CM INSPECTION

1. Disconnect the DSC HU/CM connector.

2. Connect the negative battery cable.

3. Attach the tester lead to the DSC HU/CM harness side connector, then inspect voltage, continuity or

resistance according to the standard (reference value) on the table.

Standard (Reference Value)

RX8 - Brakes