AUDIO CONTROL SWITCH INSPECTION
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module.(See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION .)
3. Disconnect the audio control switch connector.
4. Verify the resistance and continuity between the audio control switch terminals.
If the resistance and continuity are not as indicated in the tables, replace the audio control light
•
switch.
R:
Resistance.See the table.
Switch position
VOL- switch ON
VOL+ switch ON
SEEK+ switch ON 286315
SEEK- switch ON 534589
MODE switch ON 9851,080
MUTE switch ON 1,9402,130
OFF
Resistance (ohm)
5156
140154
4,8005,290
(w)
RX-8 Body
Page 263