Mazda RX-8 Manual page 1173

Turn the ignition switch to the LOCK
•
position.
Inspect the TFT sensor.
•
(See TRANSMISSION FLUID
TEMPERATURE (TFT) SENSOR
INSPECTION .)
Is the TFT sensor normal?
•
VERIFY TROUBLESHOOTING OF DTC
P0711 COMPLETED
Make sure to reconnect all
•
disconnected connectors.
Clear the DTC from the TCM memory
•
7 using the WDS or equivalent.
Decrease ATF temperature to 20 ° ° ° ° C
•
{68 ° ° ° ° F} or less .
Start the engine.
•
Drive the vehicle for 6.5 min or more .
•
Is the same DTC present?
•
VERIFY AFTER REPAIR PROCEDURE
Perform the "After Repair Procedure".
•
8
(See AFTER REPAIR PROCEDURE
.)
Are any DTCs present?
•
Replace the TFT sensor, then go to the next step.
No
(See TRANSMISSION FLUID TEMPERATURE
(TFT) SENSOR REMOVAL/INSTALLATION .)
Replace the TCM, then go to the next step.
Yes
(See TCM REMOVAL/INSTALLATION .)
No Go to the next step.
Go to the applicable DTC inspection.
Yes
(See DTC TABLE .)
No DTC troubleshooting completed.
(w) RX-8 Transmission (Manual & Auto)
Page 148