Mazda RX-8 Manual page 1646

2. Push the SST (49 N061 0A0) with your thumb until it snaps into the clamp.
CAUTION:
Excessive force to the SST (49 N061 0A0) may damage the clamp. Be careful not to press hard
•
when inserting the SST (49 N061 0A0) into the clamp.
3. Raise the stopper, and pull the SST (49 N061 0A0) from the piping.
4. Remove the SST (49 N061 0A0) from the clamp.
CAUTION:
Be careful not to bend the SST (49 N061 0A0) needle when removing the clamp. If the SST (49
•
N061 0A0) needle is bent, the clamp can not be opened.
Refrigerant Line Installation Note
1. Apply compressor oil to the O-ring joints.
2. Tighten the piping joints.
(w) RX-8 - HVAC
Page 17