Mazda RX-8 Manual page 2067

4. Select "Body/Security/PATS function" from the screen menu of the WDS or equivalent.
5. Perform security access as indicated on the WDS or equivalent screen. (See No.6 Security Access
Procedure .)
6. Select "Parameter Reset" from the screen menu of the WDS or equivalent.
7. Perform security access again as indicated on the WDS or equivalent screen. (See No.6 Security Access
Procedure .)
8. Select the replaced part as indicated on the WDS or equivalent screen.
When replacing only the PCM: Select "PCM".
•
When replacing only the keyless control module: Select "RKE".
•
NOTE:
At this time, do not select any other parts from the screen menu of the WDS or equivalent.
•
9. After verifying that the PATS function menu is displayed again on the WDS or equivalent screen, select
"Exit" to complete the WDS or equivalent function.
10. After Step 9, wait 10 s or more and turn the ignition switch to the LOCK position using key 1.
11. Using key 1, turn the ignition switch to the ON position.
NOTE:
When replacing only the PCM: The security light illuminates for 3 s and then goes out.
•
When replacing only the keyless control module: Although the security light flashes and DTC 21
•
is displayed, this does not indicate an improper procedure. Continue to perform the procedure as
indicated.
12. Perform the following procedures:
(w) RX-8 Body
Page 349