Front Crossmember Removal/Installation - Mazda RX-8 Manual

FRONT CROSSMEMBER

FRONT CROSSMEMBER REMOVAL/INSTALLATION

CAUTION:
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly
•
cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following
procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the
sensor will not be pulled while servicing the vehicle.
1. Remove the front suspension tower bar.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the front wheel alignment.
5. Set the EPS system to the neutral position.
CAUTION:
After disconnecting the steering shaft joint, always set the EPS system to the neutral position to
•
prevent system malfunction.
(w) RX-8 Suspension
Page 17