Resistance Inspection
1. Measure the resistance between the ABS wheel-speed sensor terminals.
If there is any malfunction, replace the front ABS wheel-speed sensor.
•
Resistance
0.792.2 kilohms
o
Voltage Pattern Inspection
1. Lift up the vehicle, and connect an oscilloscope to the ABS wheel-speed sensor connector.
2. While rotating each wheel by hand inspect the voltage pattern.
If there is distortion or noise, replace the front ABS wheel-speed sensor.
•
Voltage pattern (reference)
Oscilloscope setting:
•
1 V/DIV (Y), 2 ms/DIV (X), AC range
Vehicle condition: Driving 30 km/h (18.6 mph)
•
NOTE:
As the vehicle speed increases, the voltage increases and the wave period shortens.
•
Sensor Output Value Inspection
1. Turn the ignition switch off.
2. Connect the WDS or equivalent to the DLC-2.
3. Select the following PIDs using the WDS or equivalent:
LF_WSPD
•
•
(w)
RX8 - Brakes
Page 41