Mazda RX-8 Manual page 1588

Caliper Component Removal Note
1. Hang the caliper component by the cable and move aside.
Rear Trailing Link (Upper) Ball Joint Removal Note
1. Using the SST , disconnect the ball joint.
NOTE:
When removing the rear trailing link (upper) ball joint, the rear knuckle bushing may also come
•
off. If it comes off, replace the rear knuckle.
Dust Boot Installation Note
1. Wipe the grease off the ball joint stud.
2. Fill the inside of the new dust boot with grease.
3. Using the SST , install the dust boot to the ball joint.
4. Wipe off the excess grease.
(w) RX-8 Suspension
Page 31