Floor Covering - Mazda RX-8 Manual

b. Sunroof seaming welt (vehicles with sunroof)
c. A-pillar trim(See A-PILLAR TRIM REMOVAL/INSTALLATION .)
d. Rear seat(See REAR SEAT REMOVAL/INSTALLATION .)
e. Inner scuff plate(See INNER SCUFF PLATE REMOVAL/INSTALLATION .)
f. Tire house trim(See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
g. Rear pillar trim(See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
h. Map light(See MAP LIGHT REMOVAL/INSTALLATION .)
i. Interior light(See INTERIOR LIGHT REMOVAL/INSTALLATION .)
j. Sunvisor(See SUNVISOR REMOVAL/INSTALLATION .)
k. Assist handle(See ASSIST HANDLE REMOVAL/INSTALLATION .)
4. Disconnect the roof wiring harness connector and remove the roof wiring harness connector clip from
the body.
5. Remove the fasteners.
6. Detach the tab from the roof panel and remove the headliner.
7. Take the headliner out from the opened passenger-side door.
8. Install in the reverse order of removal.

FLOOR COVERING

FLOOR COVERING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Front seat(See FRONT SEAT REMOVAL/INSTALLATION .)
b. Rear seat(See REAR SEAT REMOVAL/INSTALLATION .)
c. Inner scuff plate(See INNER SCUFF PLATE REMOVAL/INSTALLATION .)
d. Ashtray illumination bulb(See ASHTRAY ILLUMINATION BULB
REMOVAL/INSTALLATION .)
e. Console(See CONSOLE REMOVAL/INSTALLATION .)
f. Front side trim(See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
g. Tire house trim(See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
h. Seat belt rail(See FRONT SEAT BELT REMOVAL/INSTALLATION .)
3. Remove fasteners A, B, and C.
4. Detach clip D and remove the floor covering.
(w) RX-8 Body
Page 156