D-Link Dis-200G Series Cli Reference Manual page 200

Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to configure the description of the ONVIF recognized IPC with only the IP address of the
IPC, or both the IP and MAC address of the IPC. If there is more than one IPC with the same IP address and
the MAC addresses of those IPCs are not specified, the description of those IPCs will be configured.
Example
This example shows how to define the description of the IPC with an IP address of 172.18.60.1 to 'ipc1'.
Switch# config terminal
Switch(config)# surveillance vlan onvif-ipc 172.18.60.1 description ipc1
Switch(config)#
35-8 surveillance vlan onvif-nvr description
This command is used to configure the description of an ONVIF recognized NVR. Use the no command to
remove this description.
surveillance vlan onvif-nvr IP-ADDRESS [mac-address MAC-ADDRESS] description TEXT
no surveillance vlan onvif-nvr IP-ADDRESS [mac-address MAC-ADDRESS] description
Parameters
IP-ADDRESS
MAC-ADDRESS
TEXT
Default
By default, there is no description defined for an ONVIF recognized NVR.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
When an ONVIF NVR is recognized, the description for specified device can be configured.
This command is used to configure the description of the ONVIF recognized NVR with only the IP address of
the NVR, or both the IP and MAC address of the NVR. If there is more than one NVR with the same IP address
and the MAC addresses of those NVRs are not specified, the description of those NVRs will be configured.
Example
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Enter the IP address of the ONVIF recognized NVR here.
(Optional) Enter the MAC address of the NVR that is recognized
with ONVIF.
Enter the description of the ONVIF recognized NVR here. This can
be up to 32 characters long.
196