D-Link Dis-200G Series Cli Reference Manual page 171

32-7 snmp-server name
This command is used to configure the system's name information. Use the no form of this command to
remove the setting.
snmp-server name NAME
no snmp-server name
Parameters
NAME
Default
By default, this name is "Switch".
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the system's name information on the Switch.
Example
This example shows how to configure the system's name to "SiteA-switch".
Switch#configure terminal
Switch(config)#snmp-server name SiteA-switch
SiteA-switch(config)#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the string that describes the SNMP server name
information. Spaces are not allowed here.
167