D-Link Dis-200G Series Cli Reference Manual page 199

MAC-ADDRESS
enable
disable
Default
By default, this feature is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to configure the ONVIF recognition IPC state with only the IP address of the IPC, or
both the IP and MAC address of the IPC. When the ONVIF IPC is recognized, the state can be configured for
the specified device. If there is more than one IPC with the same IP address and the MAC addresses of those
IPCs are not specified, the state of those IPCs will be affected.
This feature is used to block IPC traffic or not. If the IPC state on the port is disabled, the traffic from the IPC
will be blocked.
Example
This example shows how to enable the state of IPC with the IP address 172.18.60.1.
Switch# config terminal
Switch(config)# surveillance vlan onvif-ipc 172.18.60.1 state enable
Switch(config)#
35-7 surveillance vlan onvif-ipc description
This command is used to configure the description of the ONVIF recognized IPC. Use the no command to
remove the description.
surveillance vlan onvif-ipc IP-ADDRESS [mac-address MAC-ADDRESS] description TEXT
no surveillance vlan onvif-ipc IP-ADDRESS [mac-address MAC-ADDRESS] description
Parameters
IP-ADDRESS
MAC-ADDRESS
TEXT
Default
By default, there is no description defined for an ONVIF recognized IPC.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Enter the MAC address of the IPC that is recognized with
ONVIF.
Specifies that the ONVIF recognition IPC state will be enabled.
Specifies that the ONVIF recognition IPC state will be disabled.
Enter the IP address of the ONVIF recognized IPC here.
(Optional) Enter the MAC address of the IPC that is recognized with
ONVIF.
Enter the description of the ONVIF recognized IPC here. This can
be up to 32 characters long.
195