D-Link Dis-200G Series Cli Reference Manual page 120

By default, this value is 0.
Command Mode
MST Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Two Ethernet switches that have the same configuration but different revision numbers are considered to be
part of two different regions.
Example
This example shows how to configure the revision level of the MSTP configuration to 2.
Switch# configure terminal
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# revision 2
Switch(config-mst)#
24-4 show spanning-tree mst
This command is used to display the information that used in the MSTP version.
show spanning-tree mst [configuration [digest]]
show spanning-tree mst [instance INSTANCE-ID]
Parameters
configuration
digest
instance INSTANCE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the MSTP configuration and operation status. If a private VLAN is configured and
the secondary VLAN does not map to the same primary VLAN, the show spanning-tree mst configuration
command will display a message to indicate this condition.
Example
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies to display the table for the mapping relationship between
VLANs and MSTP Instances.
Specifies to display the MD5 digest included in the current MST
configuration identifier (MSTCI).
Specifies to display the MSTP information for the designated
instance only.
116