D-Link Dis-200G Series Cli Reference Manual page 75

Level: 15.
Usage Guideline
The command is available for both physical ports and port-channel interface configuration. Administrators can
use the gvrp advertise command to enable the specified VLANs' GVRP advertise function on the specified
interface. The command only takes effect when GVRP is enabled. The command only takes effect for hybrid
mode and trunk mode.
Example
This example shows how to enable the advertise function of VLAN 1000 on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config-if)# gvrp advertise 1000
Switch(config-if)#
14-4 gvrp vlan create
This command is used to enable dynamic VLAN creation. Use the no form of this command to disable the
dynamic VLAN creation function.
gvrp vlan create
no gvrp vlan create
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
When dynamic VLAN creation is enabled, if a port has learned a new VLAN membership and the VLAN does
not exist, the VLAN will be created automatically. Otherwise, the newly learned VLAN will not be created.
Example
This example shows how to enable the creation of dynamic VLANs registered with the GVRP protocol.
Switch# configure terminal
Switch(config)# gvrp vlan create
Switch(config)#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
71