Basic Ipv6 Commands - D-Link Dis-200G Series Cli Reference Manual

6.

Basic IPv6 Commands

6-1 ipv6 address
This command is used to manually configure an IPv6 addresses on the management VLAN . Use the no form
of this command to disable IPv6 address for management VLAN.
ipv6 address IPV6-ADDRESS
no ipv6 address
Parameters
IPV6-ADDRESS
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the IPv6 address of management VLAN. Use no form of this command to
disable IPv6 address for management VLAN.
Example
This example shows how to configure an IPv6 address.
Switch# config terminal
Switch(config)# interface vlan 1
Switch(config-if-vlan)# ipv6 address 3ffe:22:33:44::55/64
Switch(config-if-vlan)#
This example shows how to disable IPv6 address for management VLAN.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# no ipv6 address
6-2 show ipv6 interface
This command is used to display IPv6 interface information.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the IPv6 address and the length of prefix for
the management VLAN.
26