D-Link Dis-200G Series Cli Reference Manual page 228

40-7 sntp enable
This command is used to enable the SNTP function. Use the no form of this command to disable the SNTP
function.
sntp enable
no sntp enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to enable or disable the SNTP function.
Example
This example shows how to enable the SNTP function.
Switch# configure terminal
Switch(config)# sntp enable
Switch(config)#
40-8 sntp interval
This command is used to set the interval for the SNTP client to synchronize its clock with the server.
sntp interval SECONDS
no sntp interval
Parameters
SECONDS
Default
By default, this value is 720 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the synchronization interval from 30 to 99999 seconds.
224