D-Link Dis-200G Series Cli Reference Manual page 204

Description
Total Entries: 1
Switch#
This example shows how to display detailed ONVIF-based IP camera information.
Switch# show surveillance vlan onvif-ipc interface Ethernet 1/0/1 detail
Interface
IP Address
MAC Address
Model
Manufacturer
State
Description
Protocol
Power Consumption: 1.9W/15W
PoE
PoE Status
Total Entries: 1
Switch#
35-12 show surveillance vlan onvif-nvr interface
This command is used to display ONVIF-based NVR and group information.
show surveillance vlan onvif-nvr interface [INTERFACE-ID [,|-]] [ipc-list]
Parameters
INTERFACE-ID
,
-
ipc-list
Default
None.
Command Mode
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
: P3384-VE
: eth1/0/1
: 10.90.90.1
: 00-01-02-03-04-05
: P3384-VE
: D-Link
: Enabled
: P3384-VE
: ONVIF
: 802.3af
: Enable
(Optional) Specifies the port to be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
(Optional) Specifies to display NVR group information.
200