D-Link Dis-200G Series Cli Reference Manual page 107

,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the loopback detection setting and status.
Example
This example shows how to displays the current loopback detection settings and status.
Switch# show loopback-detection
Loop Detection : Enabled
Interval
Recover Time
Interface
--------------
Ethernet1/0/1
Ethernet1/0/2
Ethernet1/0/3
Ethernet1/0/4
...
Port-channel1
Port-channel2
Switch#
This example shows how to displays the loopback detection status for port 1/0/1.
Switch# show loopback-detection interface Ethernet 1/0/1
Interface
--------------
Ethernet1/0/1
Switch#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces are allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No spaces are allowed
before and after the hyphen.
: 20 seconds
: 60 seconds
State Result
-------- ----------------- ---------------
Disabled Normal
Disabled Normal
Enabled Loop
Enabled Loop
Enabled Loop
Disabled Normal
State Result
-------- ----------------- ---------------
Disabled Normal
Time Left (sec)
-
-
120
115
50
-
Time Left (sec)
-
103