D-Link Dis-200G Series Cli Reference Manual page 45

Parameters
30
60
90
120
Never
Default
By default, this option is 30 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure interval between two consecutive DDP report messages.
Example
This example shows how to configure interval to 60 seconds.
Switch# configure terminal
Switch(config)# ddp report-timer 60
9-3 show ddp
This command is used to display the switch DDP configurations.
show ddp
Parameters
none
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the switch DDP configuration information.
Example
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the report interval to 30 seconds.
Specifies the report interval to 60 seconds.
Specifies the report interval to 90 seconds.
Specifies the report interval to 120 seconds.
Specifies to stop sending report message.
41