D-Link Dis-200G Series Cli Reference Manual page 140

27-2 show port-security
This command is used to display the current port security settings.
show port-security [[interface INTERFACE-ID [, | -]] [address]
Parameters
INTEFACE-ID
,
-
address
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the current port security settings.
Example
This example shows how to display the port security settings of interfaces eth1/0/1 to eth1/0/3.
Switch# show port-security interface eth 1/0/1-3
Interface
No.
------------ ----- ----- -------- -------------------- -------- ------------
eth1/0/1
eth1/0/2
eth1/0/3
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the ID of the interface to be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Specifies to display all the secure MAC addresses, including both
configured and learned entries.
Max Curr Violation
No. No. Act.
32 0 Protect -
32 0 Protect -
32 0 Protect -
Violation Admin
Count State
Disabled -
Disabled -
Disabled –
136
Current
State