D-Link Dis-200G Series Cli Reference Manual page 227

SNTP Poll Interval
SNTP Server Status:
SNTP Server
---------------------------------------------- ------- ------- ---------------
10.10.1.112
---------------------------------------------- ------- ------- ---------------
Total Entries : 1
Switch#
40-6 sntp server
This command is used to allow the system clock to be synchronized with an SNTP time server. Use the no
form of this command to remove the configuration.
sntp server {IP-ADDRESS}
no sntp server
Parameters
IP-ADDRESS
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
SNTP is a compact, client-only version of the NTP. Unlike NTP, SNTP can only receive the time from NTP
servers; it cannot be used to provide time services to other systems. SNTP typically provides time within 100
milliseconds of the accurate time, but it does not provide the complex filtering and statistical mechanisms of
NTP.
Use the no form of this command to delete the SNTP server configuration. The time obtained from the SNTP
server refers to the UTC time.
Example
This example shows how to configure a switch to allow its software clock to be synchronized with the clock by
the SNTP server at IP address 10.10.1.143.
Switch# config terminal
Switch(config)# sntp server 10.10.1.143
Switch(config)#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
: 720 sec
Specifies the IP address of the time server which provides the clock
synchronization.
Stratum Version Last Receive
0 4
223
-