D-Link Dis-200G Series Cli Reference Manual page 135

Command Default Level
Level: 15.
Usage Guideline
Use this command to enable or disable the specified port's EEE power saving function. The Energy-Efficient
Ethernet (EEE) power-saving mode saves power consumption while a link is up when there s low utilization of
packet traffic. The physical interface will enter into a Low Power Idle (LPI) mode when there is no data to be
transmitted. In the EEE power-saving mode, power consumption is scalable to the actual bandwidth utilization.
Example
This example shows how to enable the EEE power saving function.
Switch(config-if)# end
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config-if)# power-saving eee
Switch(config-if)#
26-4 power-saving dim-led time-range
This command is used to configure the time range profile for the dim LED schedule. Use the no form of this
command to delete the specified time range profile.
power-saving dim-led time-range PROFILE-NAME
no power-saving dim-led time-range PROFILE-NAME
Parameters
PROFILE-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to add or delete a time range profile for the dim LED schedule. When the schedule is up, all
port's LED will be turned off.
Example
This example shows how to add a time-range profile for the dim LED schedule.
Switch(config)# end
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config-if)# power-saving dim-led time-range day-time
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the name of the time range profile to be configured. The
maximum length is 32 characters.
131