D-Link Dis-200G Series Cli Reference Manual page 69

Switch(config)#
13-6 show mac-address-table
This command is used to display a specific MAC address entry or the MAC address entries for a
specific interface or VLAN.
show mac-address-table [dynamic | static] [address MAC-ADDR | interface [INTERFACE-ID |
vlan VLAN-ID]
Parameters
dynamic
static
address MAC-ADDR
interface INTERFACE-ID
vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the option interface is specified, the unicast entry that has the forwarding interface matches the
specified interface will be displayed
Example
This example shows how to display all the MAC address table entries for the MAC address 00-02-4b- 28-c4-82.
Switch# show mac-address-table address 00:02:4B:28:C4:82
VLAN MAC Address
------ ------------------ -------- --------
1 00-02-4B-28-C4-82
Total Entries: 1
Switch#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Specifies to display dynamic MAC address table entries
only.
(Optional) Specifies to display static MAC address table entries
only.
(Optional) Specifies the 48-bit MAC address.
(Optional) Specifies to display information for a specific interface.
Valid interfaces include physical ports and port-channels.
(Optional) Specifies the VLAN ID. The valid values are from 1 to
4094.
Type
Static
Ports
CPU
65