D-Link Dis-200G Series Cli Reference Manual page 220

The following is a table for the facility.
Numerical code
16
17
18
19
20
21
22
23
Example
This example shows how to enable the logging of system messages with a severity higher than warnings to the
remote host 10.10.1.141.
Switch# configure terminal
Switch(config)# logging server 10.10.1.141 severity warnings
Switch(config)#
38-4 logging source-interface
This command is used to specify the interface whose IP address will be used as the source address for
sending the SYSLOG packet. Use the no form of this command to disabled sending the packet.
logging source-interface INTERFACE-ID
no logging source-interface
Parameters
source-interface INTERFACE-ID
Default
By default, sending the SYSLOG packet is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to specify the interface whose IP address will be used as the source address of the
SYSLOG packet. The interface MUST be management vlan interface.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Facility
Local use 0 (local0).
Local use 1 (local1).
Local use 2 (local2).
Local use 3 (local3).
Local use 4 (local4).
Local use 5 (local5).
Local use 6 (local6).
Local use 7 (local7).
Specifies the interface whose IP address will be used as the source
address of the SYSLOG packet.
216