D-Link Dis-200G Series Cli Reference Manual page 15

2-3 logout
This command is used to close an active terminal session by logging off the Switch.
logout
Parameters
None.
Default
None.
Command Mode
User EXEC Mode.
Privilege EXEC Mode.
Command Default Level
Level:1.
Usage Guideline
Use this command to close an active terminal session by logging out of the device.
Example
This example shows how to logout
Switch# logout
2-4 end
This command is used to end the current configuration mode and return to the highest mode in the CLI mode
hierarchy which is either the User EXEC Mode or the Privileged EXEC Mode.
end
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
E xecuting this command will return access to the highest mode in the CLI hierarchy regardless of what
configuration mode or configuration sub-mode currently located at.
Example
This example shows how to end the Interface Configuration Mode and go back to the Privileged EXEC Mode.
Switch# configure terminal
Switch(config)# interface eth1/0/1
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
11