D-Link Dis-200G Series Cli Reference Manual page 185

33-2 show spanning-tree configuration interface
This command is used to display the information about STP interface related configuration.
show spanning-tree configuration interface [INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display Spanning Tree interface level configuration. The command can be used for all
STP versions.
Example
This example shows how to display spanning tree configuration information for interface Ethernet 1/0/1.
Switch#show spanning-tree configuration interface Ethernet 1/0/1
eth1/0/1
Port fast: edge
Switch#
33-3 snmp-server enable traps stp
This command is used to enable the spanning tree to send SNMP notifications for STP. Use the no form of this
command to disable the sending of notifications for STP.
snmp-server enable traps stp [new-root] [topology-chg]
no snmp-server enable traps stp [new-root] [topology-chg]
Parameters
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the interface ID to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and
after the hyphen.
181