D-Link Dis-200G Series Cli Reference Manual page 131

Example
This example shows how to enable the PoE PD alive check function on interface eth1/0/1-2.
Switch# configure terminal
Switch(config)# interface range Ethernet 1/0/1-2
Switch(config-if-range)#poe pd alive
Switch(config-if-range)#
This example shows how to configure the IP address of the target PD.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/2
Switch(config-if)# poe pd alive ip 192.168.1.150
Switch(config-if)#
This example shows how to configure the interval between ping requests.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/2
Switch(config-if)# poe pd alive interval 60
Switch(config-if)#
This example shows how to configure the retry counts of ping requests.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/2
Switch(config-if)# poe pd alive retry 4
Switch(config-if)#
This example shows how to configure the waiting time for PD to reboot.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/2
Switch(config-if)# poe pd alive waiting-time 120
Switch(config-if)#
This example shows how to configure the action to reset when PD does not reply.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/2
Switch(config-if)# poe pd alive action reset
Switch(config-if)#
25-7 show poe pd alive
This command is used to display the PD alive check settings.
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
127