D-Link Dis-200G Series Cli Reference Manual page 29

Interface
---------------- -------------------- -------- ------
VLAN 1
Switch#
5-4 show ip route
This command is used to display ip address of default gateway.
show ip route
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the ip address of default gateway.
Example
This example shows how to display ip address of default gateway.
Switch(config-if-vlan)# show ip route
Code: C - connected, S - static
* - candidate default
Gateway of last resort is 10.90.90.254 to network 0.0.0.0
C 10.90.90.0/24 is directly connected, vlan1
Total Entries: 1
Switch(config-if-vlan)#
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Address
10.90.90.91/24
Method Status
Manual UP
25