D-Link Dis-200G Series Cli Reference Manual page 115

23-5 show ipv6 mld snooping
This command is used to display MLD snooping information on the Switch.
show ipv6 mld snooping [vlan VLAN-ID]
Parameters
vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD snooping configurations.
.
Example
This example shows how to display MLD snooping configurations.
Switch# show ipv6 mld snooping
MLD snooping global state : Enabled
VLAN #1 Configuration
MLD snooping state
Querier state
Fast Leave state
Switch#
23-6 show ipv6 mld snooping groups
This command is used to display MLD snooping group-related information learned on the Switch.
show ipv6 mld snooping groups [IPV6-ADDRESS | vlan VLAN-ID]
Parameters
IPV6-ADDRESS
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
(Optional) Specifies the VLAN to be displayed.
(Optional) Specifies the group IPv6 address. If no IPv6 address is
specified, all MLD group information will be displayed.
: Enabled
: Disabled
: Enabled
111