D-Link Dis-200G Series Cli Reference Manual page 56

Command Mode
ERP Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to specify or remove the first ring port of a physical ring.
Example
This example shows how to configure the interface "eth1/0/1" as the first ring port of the G.8032 ring "ring1".
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring1
Switch(config-erp)# instance 1
Switch(config-erp-instance)# port0 interface eth1/0/1
Switch(config-erp-instance)#
port1
11-10
This command is used to specify the second ring port of a physical ring. Use the no form of this command to
remove the settings.
port1 {interface INTERFACE_ID | none}
no port1
Parameters
INTERFACE-ID
none
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to specify or remove the first ring port of a physical ring. Use the port1 none command to
indicate that the inter-connect node is a local node endpoint of an open ring.
Example
This example shows how to configure the inter-connect node as a local end node of the G.8032 ring "ring2".
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring2
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the interface ID of the first ring port. The interface(s) can
be a physical interface or a port-channel.
Specifies that the inter-connect node is a local node endpoint of an
open ring.
52