D-Link Dis-200G Series Cli Reference Manual page 246

Parameters
MINUTES
Default
By default, this value is 720 minutes.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the aging time for aging out the voice device and the voice VLAN automatically
learned member ports. When the last voice device connected to the port stops sending traffic and the MAC
address of this voice device is aged out from FDB, the voice VLAN aging timer will be started. The port will be
removed from the voice VLAN after the expiration of the voice VLAN aging timer. If voice traffic resumes during
the aging time, the aging timer will be cancelled.
Example
This example shows how to configure the aging time of the voice VLAN to 30 minutes.
Switch# configure terminal
Switch(config)# voice vlan aging 30
Switch(config)#
44-3 voice vlan enable
This command is used to enable the voice VLAN state of ports. Use the no form of this command to disable
the voice VLAN's port state.
voice vlan enable
no voice vlan enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
The command takes effect for access ports or hybrid ports. Use the voice vlan enable command to enable the
voice VLAN function for ports. Both the voice vlan command in the global configuration and the voice vlan
enable command in the interface configuration mode need to be enabled for a port to start the voice VLAN
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
Specifies the aging time of the voice VLAN. The valid range is from
1 to 65535 minutes.
242